Verint Nextiva S1700e Series Manuel d'utilisateur télécharger pdf (Page 76)

6: Managing Connections

64 Verint Video Solutions

2. Select a transmitter in the left column and a receiver in the

right one.

In the Transmitters column, you have access to the two

encoders of each input. The video stream is the same for

both.

If you are using the web interface on an S1600e, S1700e,

or S2500e device, use Stream2 for the point-to-point

connection.

3. To disable I/O data transmission, clear Forward I/O.

4. To disable serial port data transmission, clear Forward

Serial Port Data.

Warning: You must clear this box if the transmitter is an

S2500e IP camera, since it does not have a serial

port.

5. To enable audio between the devices, ensure that Enable

Audio is checked, then select the audio mode.

6. Click Connect.

You should now have video on the monitor connected to the

receiver device.

Removing a Connection

You can remove an existing point-to-point connection between

two devices. Removing a connection means that no more data

will be transmitted between the two.

To remove a connection:

1. In the Active Connections box of the Connections tab,

select a connection, then click Remove.

A confirmation window appears.

2. Click OK.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 98 99

Pas de commentaire

Verint Nextiva S1700e Series Manuel d'utilisateur Page 76