Verint Nextiva S1700e Series Manuel d'utilisateur télécharger pdf (Page 57)

SConfigurator User Manual

Verint Video Solutions 45

4. Click OK.

Performing a Batch

Network Configuration

You can configure the IP network settings of a batch of devices

belonging to the same subnet in a single operation. For more

information about these settings, see page 19.

Two methods are available to set the IP addresses: DHCP or

manual. For more details on DHCP, see Appendix A on page 71.

To perform a batch network configuration:

1. In the Units box, hold down the Ctrl key while selecting the

devices to be configured.

2. Right-click in the selection, then choose Batch Network

Configuration from the contextual menu.

The Batch Network Configuration window appears.

3. To assign IP addresses with DHCP, check Use DHCP.

The next four fields become greyed out.

4. Change the fields as required.

In manual mode, you do not have to enter the ending IP

address since it is automatically assigned according to the

number of devices to configure: The address of each device

is incremented by one.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 98 99

Pas de commentaire

Verint Nextiva S1700e Series Manuel d'utilisateur Page 57