Verint Nextiva S1700e Series Guide d'installation télécharger pdf (Page 18)

2: Configuration and Installation

8 Verint Video Solutions

Configuration

The configuration steps to execute are:

 Assembling the power-over-Ethernet kit (on the PoE devices only)

 Setting a series of parameters, including the IP address

 Establishing a point-to-point connection between a receiver and a

transmitter, if required

To configure the device, you need the proprietary SConfigurator tool. It is

included on the SmartSight Utilities CD shipped with your device; you

can also find its latest version on the Verint Video Solutions extranet

(Technical Support, then Downloads, then Firmware Upgrades). You have

to copy its executable file to the hard disk of your computer.

The minimum hardware and software requirements for the host computer

needed to configure the edge device are:

 An Ethernet network card

 A serial port (not through a USB converter)

 Internet Explorer 6.0

 Microsoft DirectX 8.1

 Windows 2000 Service Pack 2 or higher, or Windows XP Service

Pack 2

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 38 39

Pas de commentaire

Verint Nextiva S1700e Series Guide d'installation Page 18