Verint Nextiva S2750e Series Guide de l'utilisateur télécharger pdf (Page 17)

Verint Video Intelligence Solutions 11

Nextiva S2750e Series User Guide

To install the camera:

1. Mount the camera:

 On the ceiling or wall, install the dome base on the mounting surface, using four

screws (not supplied); for their specification, see page 7.

 On an electrical box, use two screws (not supplied).

6. Feed the cables through the bottom or side hole on the outer case. Ensure that the

cables exit out of the hole without being crushed.

7. If the camera uses 12V DC:

a. Establish its Ethernet connection by plugging a cable (straight-through or

crossover) between the RJ-45 connector at the end of the Ethernet cable and a

device.

The crossover cable directly connects the IP camera to a computer; use a

straight-through cable to connect the IP camera to a hub or a switch for integration

with the network.

b. Tie together the camera power wires to those of the power supply (see page 9).

8. If the camera uses PoE, perform the power and Ethernet connection (see page 10).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 73 74

Pas de commentaire

Verint Nextiva S2750e Series Guide de l'utilisateur Page 17